Planning conditions for bathroom

Bathroom requirements
Wet area dry area
1. Wet area and dry area
Must be separated, power control switch must be installed in the dry zone.

2. Shower area floor
Shower area floors must be waterproof and covered with non-slip tile.
Architectural requirements

3. smallpox thickness luxury head shower, its own net weight of 25KG,
the water will reach the shower More than 35KG. Therefore, the
thickness of smallpox must be more than 15CM, and smallpox material
It has to be strong enough.

4. the height of smallpox must be above 2.3M, so as not to affect the effect
of the shower,The aesthetic effect of the bathroom.

5. Wall thickness The wall thickness must be above 15CM to ensure the
embedment of the hidden faucet.Install.
Requirements for water supply and drainage

6. Hot water supply
Maximum working water pressure :0.8Mpa;
Ideal working water pressure :0.25-0.45Mpa;
Maximum water temperature :70℃ ;
Ideal water temperature: 15℃ -65℃
Minimum hot water allowance: For continuous use of the shower system
Numbers are the ultimate determinant;
To ensure a person's full enjoyment of the shower system, hot water
Minimum barrier at least 250L above.

7. Tap inlet and outlet water connection pipe
Mix two 3/4 "(hot and cold) intake pipes and five 1/2" Water outlet pipe

8. Drainage system
The minimum displacement of the drainage system is above 60L per
minute.
Note: All pipes must be drained to remove impurities before connecting to any
component of the shower system (faucet, overhead shower, position shower, etc.) to
avoid clogging and damage to the shower system components.
Requirements for power supply

9. Power Cord
5 the x1. 5 was

10. Power control
The switch must be installed in the dry zone